Leveling the excavator arm

To optimize the work routine of an excavator, the absolute position of the moving parts to each other must be known. Inclination sensors TMS/TMM88 reliably record this position by measuring the inclination of the upper and lower carriage and the excavator arm. Absolute encoder AHS/AHM36 on the respective arm joints can support the measurement.

  • Following product families can be used
    • Inclination sensor with measuring range of 360° (single-axis) or ±90° (dual-axis)
    • Compensated cross sensitivity and configurable vibration suppression
    • Freely configurable current or voltage interface or convenient CANopen interface
    • Accuracy up to ±0.02°
    • Plastic or aluminum housing
    • Programmable with the PGT-12-Pro
    • 36 mm absolute encoder with max. 26 bits (singleturn: 14 bits, multiturn: 12 bits)
    • Face mount/servo flange, blind hollow shaft
    • Rotatable male connector or cable connection
    • IO-Link, CANopen, SAE J1939, SSI interface with programmable parameterization
    • Diagnostic functions
    • Stainless steel (Inox versions)
    • Enclosure rating up to IP67 or IP69K